*Trocad*

P R O D U C T D E T A I L S

PHASE CHANGE THERMAL PADS T-2000

Low Thermal Impedance

High Dielectric Strength

High Cut Through Resistance

60°C Phase Change Temperature

Phase Change refers to the characteristics of the Thermal Compound used to transition or change to a fluid state and back to a solid state at predetermined temperatures. During the change to its fluid state the compound expands 15% in volume allowing it to move and wet both mounting surfaces and fill all interstitial voids between them. This eliminates airpockets, allowing maximum heat transfer. T-2000 is composed of a specialized heat conducting polyamide insulating substrate coated both sides with a proprietary phase change thermal compound that offers unique heat transfer advantages. The controlled flow permits conformal setting of the material. Wetting action eliminates voids due to mounting surface irregularity.

Typical Properties	T-250
Part prefix code	T-250
Thickness (mm)	0.076
Thermal Impedance (°C-in²/W)	.20
Thermal Conductivity (W/m-K)	0.45
Dielectric Strength, VAC/mil(min)	2200
Tensile Strength PSI AT 23°C	18000
Volume Resistivity, ohm-cm at 200°C	10
Dielectric Constant at 1 kHz	4.2
Cut-through Resistance (lbs)	40
Colour	Grey

Other Products Available:
1.	Heatsink Compund R-322
2.	Thermal Pads T-177 / T-228
3.	Thermal Pads T-250
4.	Phase Change Thermal Pads T-2000
5.	Thermal Pads Flexible Tubes
6.	T-Clips

Help us keep you informed about our new products by registering with us.Register !!

Site Map